Black Friday: Pro Kit and Classic MK2 Kit reduced, drive lug cheaper with a Pro Kit – until 29 Nov only. See the offers →

In short: The Drillstarter replaces the roller starter. One part stays on the flywheel (the freewheel unit on the Classic MK2, the drive lug on the Pro). The cordless drill with the drive unit is plugged into it and turns the engine over. Then the freewheel releases the connection.

Video: how to operate the Drillstarter.

Video: installation.

What you need

  • Cordless drill or a mains drill (220 V) (guide)
  • Step drill (approx. 30 mm hole, centred in the ignition cover)

Installation (4 steps)

  1. Remove the ignition cover (manual illustration: Daytona Anima 190).
  2. Put the freewheel unit (Classic MK2) or drive lug (Pro) on the flywheel and screw it into the thread for the flywheel puller, up to the stop. The part tightens itself on first use.
  3. Note: left-hand thread (M27x1 LH). The thread should carry corrosion protection; it ships with copper paste.
  4. Check first: flywheel and central nut must be tight. A loose flywheel damages the crankshaft even without the Drillstarter.
  5. Drill the cover hole: about 30 mm with a step drill, centred.
  6. Refit the cover and check that the hole lines up.

First start (steps)

  1. Insert the drive unit into the drill chuck and tighten it.
  2. Fully charge the battery.
  3. Select 2nd gear on the drill.
  4. Select the drilling mode – never hammer-drill mode.
  5. Set the direction of rotation anticlockwise (left).
  6. Plug the drive unit into the socket on the flywheel part (Classic: freewheel unit socket; Pro: drive lug socket). Keep it axially aligned (Classic MK2): tilted engagement stresses the parts unnecessarily.
  7. Find the start position: turn the whole drill anticlockwise. You will feel areas of high and low resistance, like going uphill and downhill. The right position is shortly after the 2nd "uphill". This gives the drill a little run-up. Quick-stop helps here.
  8. Hold the drill firmly with both hands and pull the trigger.

Important notes

  • Never start in 1st gear of the cordless drill: the speed is too low and compression forces are high – risk of injury.
  • No impact driver, never hammer-drill mode: it can destroy the freewheel unit.
  • Installation and operation are at your own risk.

If something does not work

  • The chuck lock screw has sheared off: unscrew the remains (left-hand thread, turn clockwise). A spare lock screw M6 × 27 mm left-hand is included. Before screwing the chuck back on, secure the thread with high-strength threadlocker, fit the screw and let it cure for a day. More screws: chuck lock screw.
  • The drill stalls or the screw keeps shearing: either the drill is too weak, or the decompressor is not working properly. Check the decompressor and valve clearance; from about 190 cc the decompressor lever is spring-loaded – the spring can weaken: fit a harder spring or pre-tension the spring by one more turn.

→ Manual (PDF) · More questions · Compatibility

Loading...
Back to top