Black Friday: Pro Kit and Classic MK2 Kit reduced, drive lug cheaper with a Pro Kit – until 29 Nov only. See the offers →

Short answer: A cordless drill (or a mains drill, 220 V) with at least 2 gears, at least 18 V, at least 1500 rpm in 2nd gear and a quick-stop function. More than 70 Nm of torque is recommended.

Requirements at a glance

Criterion Requirement Why
Gears at least 2 Starting is done in 2nd gear.
2nd-gear speed at least 1500 rpm Manual V1.1.1
Battery voltage at least 18 V More voltage means more torque.
Torque more than 70 Nm recommended Recommendation per FAQ/manual.
Quick-stop essential Helps to find the start position.
Functions do not use impact function Impact driver/hammer mode can destroy the freewheel unit.
Direction left (anticlockwise) Drillstarter operation

A concrete example

Recommendation: Einhell TP-CD 18/80 Li-i BL with 80 Nm and a 2.5 Ah battery.

Important notes

  • Never start in 1st gear of the cordless drill: speed too low, high compression forces, risk of injury.
  • Do not use an impact driver and never select hammer-drill mode.
  • Drill too weak? It stalls or the chuck lock screw shears off. → Solution in the FAQ

Questions and answers

Is a 12 V cordless drill enough? The manual specifies at least 18 V; operation below that is not intended.

Can I use a mains-powered drill? Yes, a 220 V drill is possible according to the manual; the requirements for gears, speed and quick-stop apply equally.

Why is quick-stop so important? You turn the drill anticlockwise to find the right start position (shortly after the second "uphill"). Quick-stop stops the drill immediately and makes this precise.

→ Installation and start · Classic MK2 Kit · Pro Kit

Loading...
Back to top